Juniper Control System (JCS) 1200 Platform Hardware Guide
4.
Figure 40: Removing the Cable Management Trays
NOTE: Three M4 screws are used to secure the upper cable management tray and
four M4 screws are used to secure the lower cable management tray.
5.
Installing a JCS 1200 Bezel Collar
Figure 41 on page 103 shows how to remove and install a bezel collar.
102
Installing a JCS 1200 Bezel Collar
Slide the interposer out of the bay.
ii.
Using a Phillips-head screwdriver, loosen the captive mounting screws on
g.
the cable management trays so that they do not secure the trays and bezel
collar to the JCS 1200 platform.
Remove the bezel collar by lifting up the bezel collar and then pulling the
h.
bezel collar away from the JCS 1200 platform.
Remove the cable management trays by using a Phillips-head screwdriver to
remove the M4 screws that secure each tray to the bezel.
If you are instructed to return the bezel collar, follow all packaging instructions
and use any packaging materials for shipping that are supplied to you.