Juniper Control System (JCS) 1200 Platform Hardware Guide
Related Topics
Replacing a JCS 1200 Power Module
Topics include:
Removing a JCS 1200 Power Module
Figure 78 on page 138 shows how to remove and install a power module.
Figure 78: Removing and Installing a JCS 1200 Power Module
To remove a power module (see Figure 78 on page 138):
1.
2.
3.
138
Replacing a JCS 1200 Power Module
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
Removing a JCS 1200 Power Module on page 138
Installing a JCS 1200 Power Module on page 139
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Open the power module handle, using one of the following procedures:
For a power module in one of the upper power module bays, push the inner
handle release to the right; then pull the handle up to the open position.
For a power module in one of the lower power module bays, push the inner
handle release to the left; then pull the handle down to the open position.
Use the handle to pull the power module out of the bay.