Replacing A Jcs 1200 Management Module Or Module Filler; Removing A Jcs 1200 Management Module Or Module Filler; Installing A Jcs 1200 Management Module Or Module Filler - Juniper JCS 1200 Hardware Manual

Juniper Control System (JCS) 1200 Platform Hardware Guide
3.
4.
5.
6.
7.
CAUTION: The release handles have a safety switch that disables power output from
the power boxes. If the release handles are not secured to the chassis with the
thumbscrews, the JCS 1200 platform will not power on.
8.
9.
10.
11.
Related Topics

Replacing a JCS 1200 Management Module or Module Filler

Topics include:

Removing a JCS 1200 Management Module or Module Filler

Figure 62 on page 125 shows how to remove and install a management module.
124
Replacing a JCS 1200 Management Module or Module Filler
Orient the fan shuttle so that fan module bays 1 and 3 are above fan module
bays 2 and 4.
Align the shuttle with the JCS 1200 chassis and push the shuttle into the chassis
until it stops.
Push the release handles to the closed position. The shuttle moves back fully
into the JCS 1200 chassis.
Tighten the four captive thumbscrews on the fan shuttle.
Tighten the captive thumbscrew on each release handle.
Install any of the following modules that you removed from the rear of the
JCS 1200 platform:
Fan modules (see "Installing a JCS 1200 Fan Module" on page 118).
Network clock fillers (see "Installing a JCS 1200 Network Clock
Filler" on page 133).
MUX card (see "Installing a JCS 1200 MUX Card" on page 131).
Alarm panel module (see "Installing a JCS 1200 Alarm Panel Module or
Module Filler" on page 96).
Reconnect any cables that you disconnected from the modules in the rear of the
JCS 1200 platform.
Reconnect the power to the JCS 1200 platform (see "Connecting the JCS 1200
AC Platform to AC Power" on page 62 or "Connecting the JCS 1200 DC Platform
to DC Power" on page 63).
Restart any Routing Engines that were powered off in the JCS 1200 platform.
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
Powering On a JCS 1200 Routing Engine on page 73
Powering Off a JCS 1200 Routing Engine on page 74
Removing a JCS 1200 Management Module or Module Filler on page 124
Installing a JCS 1200 Management Module or Module Filler on page 125