Tools And Parts Required To Install The Jcs 1200 Platform Without A Mechanical Lift; Removing Components From The Jcs 1200 Platform; Lifting The Jcs 1200 Platform Into The Rack Or Cabinet - Juniper JCS 1200 Hardware Manual

Tools and Parts Required to Install the JCS 1200 Platform Without a Mechanical Lift

To install the platform, you need the following tools and parts:
Related Topics

Removing Components from the JCS 1200 Platform

Before lifting the JCS 1200 platform, you must remove the following components:
NOTE: For detailed instructions on removing JCS 1200 components, see the removal
procedures for each component.
To remove the components from the JCS 1200 platform:
1.
2.
3.
4.
5.
Related Topics
Phillips (+) screwdriver, number 2
ESD grounding wrist strap
Installing the JCS 1200 Mounting Hardware for a Four-Post Rack or
Cabinet on page 44
Installing the JCS 1200 Mounting Hardware for an Open-Frame Rack on page 46
Removing Components from the JCS 1200 Platform on page 55
Lifting the JCS 1200 Platform into the Rack or Cabinet on page 56
Fan modules
Fan shuttle
Management modules
Media trays
Power modules
Routing Engines
Switch modules
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Slide each component out of the chassis evenly so that it does not become stuck
or damaged.
Label each component as you remove it so you can reinstall it in the correct
location.
Immediately store each removed component in an electrostatic bag.
Do not stack removed components. Lay each one on a flat surface.
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
Tools and Parts Required to Install the JCS 1200 Platform Without a Mechanical
Lift on page 55
Tools and Parts Required to Install the JCS 1200 Platform Without a Mechanical Lift
Chapter 6: Installing the JCS 1200 Platform
55