Jcs 1200 Power Module Leds - Juniper JCS 1200 Hardware Manual

Verifying that the JCS 1200 Platform is Powered On Correctly
After you connect the cables to the modules and route the cables, complete the
following steps to start the JCS 1200 platform and verify that it is working correctly:
1.
2.
3.
Related Topics
Make sure that the following LEDs are lit, which indicate that the device is working
correctly:
Input power and output power LEDs on each power module
OK LED on each management module
LED on each switch module
OK
Make sure that the power-on LED on each Routing Engine is lit, either steady or
flashing slowly.
Make sure there are no fault or error LEDs lit on any of the modules.
JCS 1200 Routing Engine Control Panel Buttons and LEDs on page 25
JCS 1200 Power Module LEDs on page 23.
JCS 1200 Management Module Connectors and LEDs on page 16
JCS 1200 Switch Module Components and LEDs on page 27
Replacing the Standard CBs in the T-series Routing Platform on page 75
Verifying that the JCS 1200 Platform is Powered On Correctly
Chapter 7: Connecting the JCS 1200 Platform
79