Figure 70: Removing And Installing A Jcs 1200 Network Clock Filler - Juniper JCS 1200 Hardware Manual

Figure 70: Removing and Installing a JCS 1200 Network Clock Filler

To remove a network clock filler (see Figure 70 on page 133):
1.
2.
3.
Installing a JCS 1200 Network Clock Filler
Figure 71 on page 134 shows how to remove and install a network clock filler.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Pull the release handle to the open position. The network clock filler moves out
of the bay approximately 0.25 in. (0.6 cm).
Slide the network clock filler out of the bay.
Chapter 10: Replacing Components in a JCS 1200 Platform
Installing a JCS 1200 Network Clock Filler
133