Juniper Control System (JCS) 1200 Platform Hardware Guide
Replacing a JCS 1200 Routing Engine
Topics include:
Removing a JCS 1200 Routing Engine
Figure 80 on page 140 shows how to remove and install a Routing Engine.
Figure 80: Removing and Installing a JCS 1200 Routing Engine
CAUTION:
To remove a Routing Engine (see Figure 80 on page 140):
1.
2.
140
Replacing a JCS 1200 Routing Engine
Removing a JCS 1200 Routing Engine on page 140
Installing a JCS 1200 Routing Engine on page 141
To maintain proper system cooling, do not operate the JCS 1200 platform without
a Routing Engine or Routing Engine filler installed in each bay.
When you remove the Routing Engine, note the bay number. Reinstalling a
Routing Engine into a different bay from the one from which it was removed
could have unintended consequences. Some configuration information and
update options are established according to bay number; if you reinstall the
Routing Engine into a different bay, you might need to reconfigure the Routing
Engine.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Issue the
shutdown T system:blade[x]
12) from the management module CLI. The command shuts down the Routing
command (where x is a value of 1 through