Removing A Jcs 1200 Management Module Filler Tray; Installing A Jcs 1200 Management Module Filler Tray; Figure 64: Removing And Installing A Jcs 1200 Management Module Filler - Juniper JCS 1200 Hardware Manual

Replacing a JCS 1200 Management Module Filler Tray
Topics include:

Removing a JCS 1200 Management Module Filler Tray

Figure 64 on page 127 shows how to remove and install a management module filler
tray.
Figure 64: Removing and Installing a JCS 1200 Management Module Filler Tray
To remove a management module filler tray (see Figure 64 on page 127):
1.
2.
3.
4.
Removing a JCS 1200 Management Module Filler Tray on page 127
Installing a JCS 1200 Management Module Filler Tray on page 128
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Remove the management module or filler from the management module bay
(see "Removing a JCS 1200 Management Module or Module Filler" on page 124).
Pull the management module filler tray release handle to the open position. The
filler tray moves out of the bay approximately 0.25 in. (0.6 cm).
Slide the filler tray out of the bay.
Replacing a JCS 1200 Management Module Filler Tray
Chapter 10: Replacing Components in a JCS 1200 Platform
127