Replacing A Jcs 1200 Bezel; Removing A Jcs 1200 Bezel; Installing A Jcs 1200 Bezel; Figure 35: Removing And Installing A Jcs 1200 Alarm Panel Module - Juniper JCS 1200 Hardware Manual

Figure 35: Removing and Installing a JCS 1200 Alarm Panel Module

To install an alarm panel module or module filler (see Figure 35 on page 97):
1.
2.
3.
4.
Related Topics

Replacing a JCS 1200 Bezel

Topics include:

Removing a JCS 1200 Bezel

If the JCS 1200 bezel option is installed on your JCS 1200 platform, you must first
remove the bezel to access any devices installed into the front of your JCS 1200
platform.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Make sure that the release handle on the alarm panel module is in the open
position.
Slide the alarm panel module into the alarm panel module bay until it stops.
Push the release handle to the closed position.
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
JCS 1200 Alarm Panel Module Description on page 12
Locating the JCS 1200 Alarm Panel Serial Number on page 197
Removing a JCS 1200 Bezel on page 97
Installing a JCS 1200 Bezel on page 98
Chapter 10: Replacing Components in a JCS 1200 Platform
Replacing a JCS 1200 Bezel
97