Figure 33: Connecting The Jcs 1200 Platform To A T-Series Routing - Juniper JCS 1200 Hardware Manual

Figure 33: Connecting the JCS 1200 Platform to a T-series Routing Platform
Repeat 2 through 5 to connect up to two additional T-series routing platforms
6.
to RJ-45 ports labeled
NOTE: To connect more than one T-series routing platform, each routing platform
must run JUNOS Release 9.2 or later.
NOTE: A switch module has six external 1000Base-T Ethernet ports for 10/100/1000
Mbps connections to external Ethernet devices, such as backbones, end stations,
and servers. These ports are identified as EXT1, EXT2, EXT3, EXT4, EXT5, and EXT6
in the switch configuration menus and are labeled
on the JCS 1200 switch module.
NOTE: The connections between the switch modules and the T-CBs are proprietary
Ethernet connections. Do not attempt to connect these components through a switch
or hub.
Connecting an Offline T-series Routing Platform to the JCS 1200 Platform
Chapter 7: Connecting the JCS 1200 Platform
and on the JCS 1200 switch module.
2 3
1 through 6 (from top to bottom)
77