Replacing A Jcs 1200 Management Module Interposer; Replacing A Jcs 1200 Media Tray; Removing A Jcs 1200 Media Tray; Installing A Jcs 1200 Media Tray - Juniper JCS 1200 Hardware Manual

Juniper Control System (JCS) 1200 Platform Hardware Guide
Installing a JCS 1200 Management Module Filler Tray
To install a management module filler tray:
1.
2.
3.
4.
5.
6.
Related Topics

Replacing a JCS 1200 Management Module Interposer

NOTE: The management module interposer is not a field-replaceable unit (FRU). You
cannot order a management module interposer separately. If the management
module interposer requires replacement, you must replace the entire chassis. For
instructions on replacing the chassis, see "Replacing a JCS 1200 Chassis" on page 113.
Related Topics

Replacing a JCS 1200 Media Tray

Topics include:

Removing a JCS 1200 Media Tray

Figure 65 on page 129 shows how to remove a media tray.
128
Installing a JCS 1200 Management Module Filler Tray
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Remove the management module filler and management module tray filler.
Make sure that the release handle on the filler tray is in the open position.
Slide the filler tray into the management module bay until it stops.
Push the filler tray release handle to the closed position.
Install a management module or filler (see "Installing a JCS 1200 Management
Module or Module Filler" on page 125).
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
Replacing a JCS 1200 Management Module Interposer on page 128
Replacing a JCS 1200 Management Module or Module Filler on page 124
Replacing a JCS 1200 Chassis on page 113
Locating the JCS 1200 Chassis Serial Number on page 196
Contacting Customer Support on page 206
Removing a JCS 1200 Media Tray on page 128
Installing a JCS 1200 Media Tray on page 129