Figure 44: Installing The Light Path Extension Assembly - Juniper JCS 1200 Hardware Manual

Juniper Control System (JCS) 1200 Platform Hardware Guide
10.
11.

Figure 44: Installing the Light Path Extension Assembly

12.
106
Installing a JCS 1200 Bezel Collar
Push the interposer release handle to the closed position.
c.
Reinstall management module 1 into management module bay 1 (see "Installing
a JCS 1200 Management Module or Module Filler" on page 125).
Install the light path extension assembly. Two light path extension assemblies
are shipped with the JCS 1200 bezel to extend the light path LEDs so that they
are visible through the bezel. Install one light path extension assembly for each
of the management modules installed in your JCS 1200 platform.
Place the light path extension assembly onto the bezel collar in front of the
a.
retention tabs. The release tab should extend slightly beyond the edge of
the collar.
Push the assembly toward the back of the collar until the release tab clicks
b.
into place. While pushing the assembly toward the JCS 1200 platform, ensure
that the locator pin is inserted into the hex locator hole to the right of the
light path LEDs on the media tray.
Install the filter frame (see "Installing the JCS 1200 Bezel Filter" on page 108).