Juniper Control System (JCS) 1200 Platform Hardware Guide
Connecting the JCS 1200 Management Module to the Network
The management module supports network connection through an Ethernet connector
or a serial connector (see Figure 30 on page 68).
Figure 30: Ports on the JCS 1200 Management Module
All management module network connections to Routing Engines are made through
the CLI. You can perform initial configuration of the management module after you
connect it to your network; however, because some requirements are imposed by
the default management module settings, it might be easier to perform these setup
operations through a direct connection.
For direct connection of a computer to the management module Ethernet connector,
you need a Category 5 or higher Ethernet cable.
Network connections through the serial connector may require an Advanced
Management Module (AMM) adapter.
See the JUNOS Protected System Domain Configuration Guide for information about
accessing the management module CLI.
The following topics describe how to make typical network connections for a
management module:
68
Connecting the JCS 1200 Management Module to the Network
Connecting the JCS 1200 AC Platform to AC Power on page 62
Connecting the JCS 1200 DC Platform to DC Power on page 63
Connecting to the JCS 1200 Management Module Using a Network Ethernet
Connection on page 69
Connecting to the JCS 1200 Management Module Using a Direct Ethernet
Connection on page 69
Connecting to the JCS 1200 Management Module Using a Console Serial
Connection on page 69
Connecting to the JCS 1200 Management Module Using a Direct Serial
Connection on page 70