Reinstalling Components into the JCS 1200 Platform
NOTE: For detailed instructions on reinstalling JCS 1200 components, see the
installation procedure for each component.
To reinstall components:
1.
2.
3.
NOTE: Make sure that all empty slots are covered with a blank panel before operating
the JCS 1200 platform.
Related Topics
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Slide each component into the chassis evenly so that it does not become stuck
or damaged.
Tighten screws, as needed, for each component.
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
Installing a JCS 1200 Fan Module on page 118
Installing a JCS 1200 Fan Shuttle on page 123
Installing a JCS 1200 Management Module or Module Filler on page 125
Installing a JCS 1200 Media Tray on page 129
Installing a JCS 1200 Power Module on page 139
Installing a JCS 1200 Routing Engine on page 141
Installing a JCS 1200 Switch Module or Module Filler on page 143
Chapter 6: Installing the JCS 1200 Platform
Reinstalling Components into the JCS 1200 Platform
57