Juniper JCS 1200 Hardware Manual page 88

Juniper Control System (JCS) 1200 Platform Hardware Guide
Lifting the JCS 1200 Platform into the Rack or Cabinet
Before you begin, see the following topics:
Lifting the chassis and mounting it in a rack requires four people. The empty chassis
weighs approximately 329 lb (149.6 kg).
1.
2.
3.
4.
5.
6.
Related Topics
56
Lifting the JCS 1200 Platform into the Rack or Cabinet
Removing a JCS 1200 Fan Module on page 116
Removing a JCS 1200 Fan Shuttle on page 122
Removing a JCS 1200 Management Module or Module Filler on page 124
Removing a JCS 1200 Media Tray on page 128
Removing a JCS 1200 Power Module on page 138
Removing a JCS 1200 Routing Engine on page 140
Removing a JCS 1200 Switch Module or Module Filler on page 143
Lifting the JCS 1200 Platform into the Rack or Cabinet on page 56
Tools and Parts Required to Install the JCS 1200 Platform Without a Mechanical
Lift on page 55
Removing Components from the JCS 1200 Platform on page 55
Ensure the rack is in its permanent location and is secured to the building.
Position the JCS 1200 platform in front of the rack or cabinet, centering it in
front of the mounting shelves. Use a pallet jack if one is available.
With one person on each side and one person in the front, hold onto the bottom
of the chassis and carefully lift it onto the large and small (if installed) mounting
shelves.
Carefully slide the JCS 1200 platform onto the mounting shelves so that the
bottom of the chassis and the mounting shelves overlap by approximately 2 in.
Install a mounting screw into each of the open mounting holes in the
rack-mounting flanges to fasten the chassis to the rack, starting from the bottom.
Visually inspect the alignment of the JCS 1200 platform. If the JCS 1200 platform
is installed properly in the rack, all the mounting screws on one side of the rack
should be aligned with the mounting screws on the opposite side, and the
platform should be level.
Tools and Parts Required to Install the JCS 1200 Platform Without a Mechanical
Lift on page 55
Removing Components from the JCS 1200 Platform on page 55
Installing the JCS 1200 Mounting Hardware for a Four-Post Rack or
Cabinet on page 44
Installing the JCS 1200 Mounting Hardware for an Open-Frame Rack on page 46