Juniper Control System (JCS) 1200 Platform Hardware Guide
Figure 32: Location of Switch Modules on the JCS 1200 Platform
To connect the T-CBs (see Figure 33 on page 77):
1.
2.
3.
4.
NOTE: The RJ-45 port labeled
5.
76
Connecting an Offline T-series Routing Platform to the JCS 1200 Platform
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Plug an ETH adapter into the top RJ-45 port (labeled
the JCS 1200 platform.
Connect one end of a UTP Category 5 cable to the ETH adapter.
Plug the other end of the cable into the port labeled
cable appropriately.
If you installed a redundant switch module into switch module bay 2:
Plug an ETH adapter into the top RJ-45 port (labeled
a.
on the JCS 1200 platform.
Connect one end of a UTP Category 5 cable to the ETH adapter.
b.
c.
Plug the other end of the cable into the port labeled
cable appropriately.
AUX
on a T-CB is reserved for future use.
1
) of switch module 1 on
CIP
on
T-CB-0
. Dress the
) of switch module 2
1
CIP
on
T-CB-1
. Dress the