Juniper Control System (JCS) 1200 Platform Hardware Guide
Ramp Warning for the JCS 1200 Platform
WARNING: When you install the routing platform, do not use a ramp inclined at
more than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10 graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10 degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related Topics
JCS 1200 Laser and LED Safety Guidelines and Warnings
Single-mode Physical Interface Cards (PICs) are equipped with laser transmitters,
which are considered a Class 1 Laser Product by the U.S. Food and Drug
Administration, and are evaluated as a Class 1 Laser Product per EN 60825–1 +A11
+A2 requirements.
Observe the following guidelines and warnings:
Class 1 Laser Product Warning for the JCS 1200 Platform
WARNING: Class 1 laser product.
160
Ramp Warning for the JCS 1200 Platform
Definition of Safety Warning Levels on page 149
Installing the JCS 1200 Platform Using a Lift on page 51
Lifting the JCS 1200 Platform into the Rack or Cabinet on page 56
Class 1 Laser Product Warning for the JCS 1200 Platform on page 160
Class 1 LED Product Warning for the JCS 1200 Platform on page 161
Laser Beam Warning for the JCS 1200 Platform on page 162
Radiation from Open Port Apertures Warning for the JCS 1200
Platform on page 163