Connecting The Jcs 1200 Platform To A T-Series Routing Platform - Juniper JCS 1200 Hardware Manual

Juniper Control System (JCS) 1200 Platform Hardware Guide
Related Topics
Powering Off a JCS 1200 Routing Engine
When you power off the Routing Engine, it is still connected to power through the
JCS 1200 platform. The Routing Engine can respond to requests from the service
processor, such as a remote request to power on the Routing Engine. To remove all
power from the Routing Engine, you must remove it from the JCS 1200 platform.
Issue the
from the management module CLI. The command shuts down the Routing Engines
cleanly, so their state information is preserved. For more information, see the JUNOS
Protected System Domain Configuration Guide.
The Routing Engine can then be powered off in any of the following ways:
Related Topics

Connecting the JCS 1200 Platform to a T-series Routing Platform

You can connect up to three of the following T-series routing platforms running
JUNOS Release 9.2 or later to the JCS 1200 platform: T320 router, T640 routing node,
and T1600 routing node. The following procedures describe connecting the JCS 1200
platform to a T-series routing platform:
74
Powering Off a JCS 1200 Routing Engine
JCS 1200 Routing Engine Description on page 24
JCS 1200 Routing Engine Control Panel Buttons and LEDs on page 25
Powering Off a JCS 1200 Routing Engine on page 74
Replacing a JCS 1200 Routing Engine on page 140
Locating the JCS 1200 Routing Engine Serial Number on page 203
shutdown T system:blade[x]
You can press the power control button for more than four seconds on the
Routing Engine behind the control panel door (see "JCS 1200 Routing Engine
Control Panel Buttons and LEDs" on page 25).
If the system is not operating correctly, the management module will
automatically power off the Routing Engine.
JCS 1200 Routing Engine Description on page 24
JCS 1200 Routing Engine Control Panel Buttons and LEDs on page 25
Powering On a JCS 1200 Routing Engine on page 73
Replacing a JCS 1200 Routing Engine on page 140
Replacing the Standard CBs in the T-series Routing Platform on page 75
Connecting an Offline T-series Routing Platform to the JCS 1200
Platform on page 75
Powering On the T-series Routing Platform on page 78
command (where x is a value of 1 through 12)