Suzuki WagonR+ RB310 Service Manual page 1873

CYLINDER HEAD COVER
REMOVAL
1) Disconnect negative cable at battery.
2) Remove air chamber case.
3) Remove high-tension cord clamps (2) from cylinder head cover.
4) Disconnect breather hose from cylinder head cover.
5) Remove cylinder head cover nuts and then seal washers (1).
6) Remove cylinder head cover (3) from cylinder head.
INSTALLATION
1) Install cylinder head cover gasket (1) to cylinder head cover (2).
NOTE:
Be sure to check each of these parts for deterioration or any
damage before installation and replace if found defective.
2) Install cylinder head cover (1).
Before installing seal washers, check each one for deterioration
or damage, and replace as necessary.
Tighten cover nuts to specified torque.
Tightening Torque
.
(a): 4.5 N m (0.45 kg-m, 3.5 lb-ft)
3) Install high-tension cord clamps (2) to cylinder head cover.
4) Connect breather hose to cylinder head cover.
5) Install air chamber case.
6) Connect negative cable at battery.
ENGINE MECHANICAL 6A-11