Suzuki WagonR+ RB310 Service Manual page 1922

6A-60 ENGINE MECHANICAL
FWD
ENGINE ASSEMBLY
REMOVAL
1) Release fuel pressure in fuel feed line by referring to Section 6-1.
2) Disconnect negative cable at battery.
3) Remove engine hood after disconnecting windshield washer
hose.
4) Drain cooling system.
WARNING:
To help avoid danger of being burned, do not remove
drain plug and radiator cap while engine and radiator are
still hot. Scalding fluid and steam can be blown out under
pressure if plug and cap are taken off too soon.
5) Disconnect radiator inlet hose from thermostat case and outlet
hose from water inlet pipe.
6) Remove air cleaner outlet hose (1) and air chamber case (2) as
previously outlined.
7) Remove suction pipe (3) and remove air cleaner assembly (4)
by removing its fastening bolt.
8) Disconnect following cables.
D Accelerator cable (1) from throttle body (2).
D Clutch cable from transmission.
D Gear shift and select cable from transmission.
9) Disconnect brake booster hose from intake manifold.