Suzuki WagonR+ RB310 Service Manual page 1900

6A-38 ENGINE MECHANICAL
VALVES AND CYLINDER HEAD
1. Cylinder head
2. Cylinder head bolt
3. Valve guide
4. Cylinder head gasket:
"TOP" mark provided on
gasket comes to crankshaft
pulley side, facing up
(toward cylinder head side).
5. Pin
6. Camshaft
7. Valve lash adjuster
8. Valve cotters
9. Valve spring retainer
10. Valve spring:
Be sure to position spring in place with
its bottom end (small-pitched) facing the
bottom (valve spring seat side).
FWD
3
11. Valve stem seal
12. Valve spring seat
13. Exhaust valve
14. Intake valve
15. Oil seal
16. Gasket
17. Camshaft housing bolt
REMOVAL
1) Relieve fuel pressure according to procedure described in Sec-
tion 6-1.
2) Disconnect negative cable at battery.
3) Drain cooling system.
4) Remove air cleaner outlet hose with air chamber case, suction
pipe and air cleaner assembly as previously outlined.
5) Disconnect oxygen sensor No.2 coupler (1) and remove ex-
haust No.1 pipe (2) with catalytic converter case (3).
: Apply engine oil to sliding
: surfaces of each part.
: Tightening Torque
: Do not reuse