Suzuki WagonR+ RB310 Service Manual page 1925

INSTALLATION
1) Lift engine with transmission into engine compartment, but do
not remove support device.
2) Install engine right mounting bracket bolts and nut.
3) Install engine left mounting nuts.
4) Install engine rear mounting nuts.
5) Tighten bolts and nuts to specified torque.
Tightening Torque
.
(a): 55 N m (5.5 kg-m, 40.0 lb-ft)
6) Remove support device.
7) Reverse removal procedures for installation of remainder.
D Install A/C compressor bracket and A/C compressor and
connect A/C suction and discharge hoses, refer to Section
1B.
D Push in each drive shaft joint fully so that snap ring engages
with differential gear.
Use care not to damage oil seal lip when inserting.
D Install stabilizer bar, refer to Section 3D of the Service Manu-
al mentioned in FOREWORD of this manual.
D Install exhaust No.1 pipe.
D Install right and left engine under covers.
D Connect each hoses securely.
D Clamp electric wire securely.
8) Adjust clutch pedal free travel, referring to Section 7C.
9) Refill transmission with gear oil, referring to Section 0B.
10) Refill engine with engine oil, referring to Section 0B.
11) Refill cooling system, referring to Section 6B.
12) Adjust A/C compressor belt, referring to Section 1B. (if equipped)
13) Upon completion of installation, verify that there is no fuel leak-
age, coolant leakage, transmission oil leakage or exhaust gas
leakage at each connection.
14) Adjust accelerator cable play, referring to Section 6E1.
ENGINE MECHANICAL 6A-63