Suzuki WagonR+ RB310 Service Manual page 1926

6A-64 ENGINE MECHANICAL
MAIN BEARINGS, CRANKSHAFT AND CYLINDER BLOCK
.
53 N m (5.3 kg-m)
REMOVAL
1) Remove engine with transmission from body as previously out-
lined.
2) Remove transmission from engine, and then remove clutch and
flywheel.
3) Remove water pump belt, generator bracket, crankshaft pulley,
timing belt, and crankshaft timing belt pulley etc.
4) Remove cylinder head assembly.
5) Remove oil pan and oil pump strainer.
6) Remove pistons and connecting rods.
7) Remove oil pump and oil seal housing.
8) Remove main bearing caps and crankshaft.
.
76 N m (7.6 kg-m)
1. Cylinder block
2. Front oil seal
3. Main bearing
.
11 N m (1.1 kg-m)
4. Bearing cap
5. Cap washer
6. Cap bolt
7. Timing pulley key
8. Crankshaft
9. Thrust bearing:
Set oil grooves of bearing to weds.
10. Rear oil seal
11. Pin
12. Oil seal housing gasket
13. Oil seal housing
14. Housing bolt
15. Input shaft bearing
16. Flywheel
17. Flywheel bolt
: Apply engine oil to sliding
: surfaces of each part.
: Tightening Torque
: Do not reuse