Renault Laguna III Manual page 3569

Passenger presence sensor cover: Removal - Refitting
a Cut the wiring around the passenger presence sen-
sor cover.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a
IMPORTANT
T o ensure the pyrotechnic components operate
correctly:
- do not bend the passenger presence sensor
pad,
- do not apply glue or adhesive to the passenger
presence sensor pad or to the seat cushion
trim.
a Attach a new passenger presence sensor cover
onto the defective cover.
Note:
The passenger presence sensor cover should fit
over the defective cover without extending over
the trim.
SAFETY ACCESSORIES
120058
a To replace the seat base trim foam, attach a new
passenger presence sensor cover by following the
marks (3) on the seat base trim foam.
a Place the wiring in the lining (4) .
a Connect the passenger presence sensor cover con-
nector.
II - FINAL OPERATION
FRONT SEAT WITH HEATING
a Attach the heated seat pad (see Heated seat pad:
Removal - Refitting) (MR 416, 79A, Seat compo-
nents).
a Refit:
- the front seat base trim (see Front seat base trim:
Removal - Refitting) (MR 416, 77A, Front seat
trim),
- the front seat lower casings (see Front seat lower
casing: Removal - Refitting) (MR 416, 77A, Front
seat trim),
- the front seat (see Complete front seat: Removal
- Refitting) (MR 416, 75A, Front seat frames and
runners).
59A-4
59A
125402