Renault Laguna III Manual page 3574

OPENING ELEMENT SEALING
Door sealing film: Removal - Refitting
D91
a Start removing the sealing film at the upper section
(1) .
a Carefully remove the mastic bead from the door box
section around the edges of the sealing film.
Note:
If the mastic bead offers too much resistance,
use a hot air gun set to approximately 100˚C held
approximately 20 cm away from the sealing film
to ease its removal.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Door sealing film
(60,03,02,10).
Note:
Remove the adhesive residue from the door box
section by applying wide masking tape over the
bonding area. Pull gently on the masking tape to
remove any adhesive residue.
134946
Clean the door frame door box section using a
lint-free cloth dipped in heptane.
WARNING
The door must be clean (free of dust, grease,
anti-adhesive products), with no trace of impuri-
ties and no condensation. The area of the inner
door panel where the film is applied must be
painted completely.
Adhesive surfaces should be at a minimum tem-
perature of 15˚ in order for the film to adhere pro-
perly to the door.
II - REFITTING OPERATION FOR PART
CONCERNED
a Remove the paper protecting the sealing film mastic
bead.
134947
Note:
Do not touch the mastic bead.
65A-2
65A