Moving The Mounting Brackets For Center-Mounting The Mx240 Router; Figure 50: Installing The Mounting Hardware For An Open-Frame Rack - Juniper MX240 Hardware Manual
3d universal edge router
Hide thumbs
Also See for MX240:
- Hardware manual (510 pages) ,
- Instruction for upgrading (35 pages) ,
- Quick start manual (31 pages)
Table of Contents
Advertisement
Related
Documentation
Moving the Mounting Brackets for Center-Mounting the MX240 Router
Copyright © 2017, Juniper Networks, Inc.
Figure 50: Installing the Mounting Hardware for an Open-Frame Rack
Moving the Mounting Brackets for Center-Mounting the MX240 Router on page 169
Installing the MX240 Router By Using a Mechanical Lift on page 177
Installing the MX240 Chassis in the Rack Manually on page 189
Two removable mounting brackets are attached to the mounting holes closest to the
front of the chassis. You can move the pair of brackets to another position on the side of
the chassis for center-mounting the router.
To move the mounting brackets from the front of the chassis toward the center of the
chassis:
Remove the three screws at the top and center of the bracket.
1.
Pull the top of the bracket slightly away from the chassis. The bottom of the bracket
2.
contains a tab that inserts into a slot in the chassis.
Pull the bracket away from the chassis so that the tab is removed from the chassis
3.
slot.
Insert the bracket tab into the slot in the bottom center of the chassis.
4.
Chapter 15: Installing the Mounting Hardware
169
Advertisement
Table of Contents
Troubleshooting
