Removing The Spacer Bars; Removing The Center-Mounting Brackets; Figure 41: Installing The Large Mounting Shelf In An Open-Frame Rack - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

Removing the Spacer Bars

Related
Documentation

Removing the Center-Mounting Brackets

80

Figure 41: Installing the Large Mounting Shelf in an Open-Frame Rack

The TX Matrix router is shipped with each spacer bar attached to the rear of a
front-mounting flange. Remove each spacer bar by removing the screws that fasten it
to the front-mounting flange.
Rack Requirements for TX Matrix Routers on page 61
Removing the Center-Mounting Brackets on page 80
If you are installing the router in a four-post rack or front-mounting the router in an
open-frame rack, you must also remove the mounting brackets from the chassis.
Copyright © 2010, Juniper Networks, Inc.