MX10008 Alarm and Management Cable
Specifications and Pinouts
IN THIS SECTION
Console Port Connector Pinouts for an MX10008 Router | 125
USB Port Specifications for the MX10008 Router | 126
Management Port Connector Pinouts for the MX10008 Router | 127
Console Port Connector Pinouts for an MX10008 Router
The console port (labeled CON) on the RCB panel is an RS-232 serial interface that uses an RJ-45 connector
to connect to a console management device. The default baud rate for the console port is 9600 baud.
Table 48 on page 125
provides the pinout information for the RJ-45 console connector. An RJ-45 cable
and RJ-45 to DB-9 adapter are supplied with the MX10008.
NOTE:
If your laptop or PC does not have a DB-9 male connector pin and you want to connect
your laptop or PC directly to an MX10008 router, use a combination of the RJ-45 cable and RJ-45
to DB-9 adapter supplied with the device and a USB to DB-9 male adapter. You must provide the
USB to DB-9 male adapter.
Table 48: Console Port Connector Pinouts for the MX10008 Router
Pin
1
2
Signal
RTS Output
DTR Output
TOD Output for PTP applications
Description
Request to send
Data terminal ready
Time of day for Precision Time Protocol
(PTP). You can use DTR pins as a TOD
universal asynchronous
receiver/transmitter (UART) by using
breakout cables.
125