Cflowd Configuration Commands - Alcatel-Lucent 7450 Configuration Manual

Cflowd Configuration Commands

Global Commands
cflowd
Syntax [no] cflowd
Context config>cflowd
Description This command creates the context to configure cflowd.
The no form of this command removes all configuration under cflowd including the deletion of all
configured collectors. This can only be executed if cflowd is in a shutdown state.
Default
no cflowd
active-timeout
Syntax active-timeout minutes
no active-timeout
Context config>cflowd
Description This command configures the maximum amount of time before an active flow is aged out of the
active cache. If an individual flow is active for this amount of time, the flow is aged out and a new
flow will be created on the next packet sampled for that flow.
Note: Existing flows do not inherit the new active-timeout value if this parameter is changed while
cflowd is active. The active-timeout value for a flow is set when the flow is first created in the active
cache table and does not change dynamically.
The no form of this command resets the inactive timeout back to the default value.
Default 30
Parameters
minutes — The value expressed in minutes before an active flow is exported.
7450 ESS Router Configuration Guide
Values 1 — 600
Cflowd
Page 635