Alcatel-Lucent 7450 Configuration Manual page 269

policy-edits
Syntax policy-edits
Context show>router
Description This command displays edited policy information.
route-table
Syntax route-table [family] [ip-prefix[/prefix-length] [longer|exact|protocol protocol-name] [all]]
[next-hop-type type][qos][alternative][accounting-class]
route-table [family] summary
route-table tunnel-endpoints [ip-prefix[/prefix-length]] [longer|exact] [detail]
route-table [<family>] [<ip-prefix[/prefix-length]>] [longer|exact|protocol
<protocol-name>] extensive [all]
Context show>router
Description
This command displays the active routes in the routing table.
If no command line arguments are specified, all routes are displayed, sorted by prefix.
Parameters family — Specify the type of routing information to be distributed by this peer group.
ip-prefix[/prefix-length] — Displays routes only matching the specified ip-address and length.
longer — Displays routes matching the ip-prefix/mask and routes with longer masks.
exact — Displays the exact route matching the ip-prefix/mask masks.
protocol protocol-name — Displays routes learned from the specified protocol.
summary — Displays a route table summary information.
tunnel-endpoints — Specifies to include tunnel endpoint information.
next-hop-type tunneled — Displays only the tunneled next-hops. For each route entry, the tunnel
Output Standard Route Table Output — The following table describes the standard output fields for the
route table.
Dest Address
7450 ESS Router Configuration Guide
Values
ipv4 — Displays only those BGP peers that have the IPv4 family enabled and not
those capable of exchanging IP-VPN routes.
mcast-ipv4 — Displays the BGP peers that are IPv4 multicast capable.
Values
ipv4-prefix:
ipv4-prefix-length:
Values
local, sub-mgmt, managed, static, ospf, ospf3, isis, rip, aggregate, bgp, bgp-vpn
owner and tunnel ID is shown.
Label
The route destination address and mask.
IP Router Configuration
a.b.c.d (host bits must be set to 0)
0 — 32
Description
Page 269