Configuring Ipv6 Parameters - Alcatel-Lucent 7450 Configuration Manual

Configuring IPv6 Parameters

IPv6 interfaces and associated routing protocols may only be configured on the following systems:
•
•
The following displays the interface configuration showing the IPv6 default configuration when
IPv6 is enabled on the interface.
A:ALA-49>config>router>if>ipv6# info detail
----------------------------------------------
' port 1/2/37
ipv6
packet-too-big 100 10
param-problem 100 10
redirects 100 10
time-exceeded 100 10
unreachables 100 10
exit
----------------------------------------------
A:ALA-49>config>router>if>ipv6# exit all
Use the following CLI syntax to configure IPv6 parameters on a router interface.
CLI Syntax: config>router# interface interface-name
The following displays a configuration example showing interface information.
A:ALA-49>config>router>if# info
----------------------------------------------
----------------------------------------------
A:ALA-49>config>router>if#
7450 ESS Router Configuration Guide
Chassis systems running in chassis mode c or d.
Chassis systems running in mixed-mode, with IPv6 functionality limited to those interface
on slots with IOM3-XPs/IMMs or later line cards.
port port-name
ipv6
address {ipv6-address/prefix-length} [eui-64]
icmp6
packet-too-big [number seconds]
param-problem [number seconds]
redirects [number seconds]
time-exceeded [number seconds]
unreachables [number seconds]
neighbor ipv6-address mac-address
address 10.11.10.1/24
port 1/2/37
ipv6
address 10::1/24
exit
IP Router Configuration
Page 81