Alcatel-Lucent 7450 Configuration Manual page 296
Hide thumbs
Also See for 7450:
- Quality of service manual (912 pages) ,
- Manual (816 pages) ,
- Configuration manual (778 pages)
Table of Contents
Advertisement
Show Commands
tunnel-table
Syntax
tunnel-table [ip-address[/mask]] [protocol protocol | sdp sdp-id] [summary]
Context
show>router
Description
This command displays tunnel table information. Note that auto-bind GRE tunnels are not displayed in
show command output. GRE tunnels are not the same as SDP tunnels that use the GRE encapsulation
type. When the auto-bind command is used when configuring a VPRN service, it means the MP-BGP
NH resolution is refering to the core routing instance for IP reachability. For a VPRN service this object
specifies the lookup to be used by the routing instance if no SDP to the destination exists.
Parameters
ip-address[/mask] — Displays the specified tunnel table's destination IP address and mask.
protocol protocol — Dislays LDP protocol information.
sdp sdp-id — Displays information pertaining to the specified SDP.
summary — Displays summary tunnel table information.
Output
Tunnel Table Output — The following table describes tunnel table output fields.
Destination
Owner
Encap
Tunnel ID
Pref
Nexthop
Metric
Sample Output
*A:Dut-D>config>service>vpls# show router tunnel-table sdp 17407
=======================================================================
Tunnel Table (Router: Base)
===============================================================================
Destination
-----------------------------------------------------------------------
127.0.68.0/32
=======================================================================
*A:Dut-D# show service id 1 sdp 17407:4294967294 detail
=======================================================================
Service Destination Point (Sdp Id : 17407:4294967294) Details
=======================================================================
-------------------------------------------------------------------------------
Page 296
Label
The route's destination address and mask.
Specifies the tunnel owner.
Specifies the tunnel's encapsulation type.
Specifies the tunnel (SDP) identifier.
Specifies the route preference for routes learned from the configured
peer(s).
The next hop for the route's destination.
The route metric value for the route.
Owner Encap TunnelId
sdp
MPLS
Description
Pref
Nexthop
17407
5
127.0.68.0
7450 ESS Router Configuration Guide
Metric
0
Advertisement
Table of Contents
