Alcatel-Lucent 7450 Configuration Manual page 178

Router Interface Commands
The no form of the command disables SNTP broadcast received on the IP interface.
Default no ntp-broadcast
port
Syntax port port-name
no port
Context config>router>interface
Description
This command creates an association with a logical IP interface and a physical port.
An interface can also be associated with the system (loopback address).
The command returns an error if the interface is already associated with another port or the system. In
this case, the association must be deleted before the command is re-attempted. The port-id can be in
one of the following forms:
The no form of the command deletes the association with the port. The no form of this command can
only be performed when the interface is administratively down.
Default
No port is associated with the IP interface.
Parameters port-name — The physical port identifier to associate with the IP interface.
Page 178
• Ethernet interfaces
If the card in the slot has MDAs, port-id is in the slot_number/MDA_number/port_number
format; for example, 1/1/3 specifies port 3 of the MDA installed in MDA slot 1 on the card
installed in chassis slot 1.
• SONET/SDH interfaces
When the port-id represents a POS interface, the port-id must include the channel-id. The POS
interface must be configured as a network port.
Values
port-id slot/mda/port[.channel]
ccag-id
lag-id
gtg-id
ccag-id.path-id[cc-type]
ccag keyword
id 1 — 8
path-id a, b
cc-type .sap-net, .net-sap
lag-id
lag keyword
id 1 — 800
gmpls-tun-grp-id
gmpls-tun-grp keyword
id 1 — 200
7450 ESS Router Configuration Guide