Alcatel-Lucent 7450 Configuration Manual page 122

Router Global Commands
Description
This command configures the local address to use for setting up the TCP connection used by an
RPKI-Router session. The default local-address is the outgoing interface IPv4 or IPv6 address. The
local-address cannot be changed without first shutting down the session.
Default no local-address
Parameters ip-address — Specifies an IPv4 address or an IPv6 address.
port
Syntax port port-id
no port
Context config>router>origin-validation>rpki-session
Description This command configures the destination port number to use when contacting the cache server. The
default port number is 323. The port cannot be changed without first shutting down the session.
Default
no port
Parameters port-id — Specifies a port-id.
refresh-time
Syntax refresh-time seconds1 hold-time seconds2
no refresh-time
Context config>router>origin-validation>rpki-session
Description This command is used to configure the refresh-time and hold-time intervals that are used for
liveness detection of the RPKI-Router session. The refresh-time defaults to 300 seconds and is reset
whenever a Reset Query PDU or Serial Query PDU is sent to the cache server. When the timer
expires, a new Serial Query PDU is sent with the last known serial number.
The hold-time specifies the length of time in seconds that the session is to be considered UP without
any indication that the cache server is alive and reachable. The timer defaults to 600 seconds and
must be at least 2x the refresh-time (otherwise the CLI command is not accepted). Reception of any
PDU from the cache server resets the hold timer. When the hold-time expires, the session is
considered to be DOWN and the stale timer is started.
Default no referesh-time
Parameters seconds1 — Specifies a time in seconds.
seconds2 — Specifies a time in seconds.
Page 122
Values
0-65535
Values 30-32767
Values 60-65535
7450 ESS Router Configuration Guide