Alcatel-Lucent 7450 Configuration Manual page 185

detail parameter is given. The save config command will not store the default tos-marking-state
trusted state for network IP interfaces unless the detail parameter is also specified.
The no form of the command is used to restore the trusted state to a network IP interface. This is
equivalent to executing the tos-marking-state trusted command.
Default trusted
Parameters
trusted — The default prevents the ToS field to not be remarked by egress network IP interfaces
untrusted — Specifies that all egress network IP interfaces will remark IP packets received on the
unnumbered
Syntax unnumbered [ip-address | ip-int-name]
no unnumbered
Context config>router>interface
Description This command sets an IP interface as an unnumbered interface and specifies the IP address to be used
for the interface.
To conserve IP addresses, unnumbered interfaces can be configured. The address used when
generating packets on this interface is the ip-addr parameter configured.
An error message will be generated if an unnumbered interface is configured, and an IP address
already exists on this interface.
The no form of the command removes the IP address from the interface, effectively removing the
unnumbered property. The interface must be shutdown before no unnumbered is issued to delete the
IP address from the interface, or an error message will be generated.
Parameters ip-addr | ip-int-name — Optional. The IP address or IP interface name to associate with the
Default no unnumbered
qos-route-lookup
Syntax qos-route-lookup [source | destination]
no qos-route-lookup
Context config>router>if
config>router>if>ipv6
Description This command enables QoS classification of the ingress IP packets on an interface based on the QoS
information associated with routes in the forwarding table.
7450 ESS Router Configuration Guide
unless the egress network IP interface has the remark-trusted state set
network interface according to the egress marking definitions on each network interface.
unnumbered IP interface in dotted decimal notation. The configured IP address must exist on this
node. It is recommended to use the system IP address as it is not associated with a particular
interface and is therefore always reachable. The system IP address is the default if no ip-addr or
ip-int-name is configured.
IP Router Configuration
Page 185