Alcatel-Lucent 7450 Configuration Manual page 217

Default
none
Parameters ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
prefix-length — Specifies a route must match the most significant bits and have a prefix length.
autonomous
Syntax [no] autonomous
Context config>router>router-advert>if>prefix
Description This command specifies whether the prefix can be used for stateless address autoconfiguration.
Default enabled
on-link
Syntax [no] on-link
Context config>router>router-advert>if>prefix
Description
This command specifies whether the prefix can be used for onlink determination.
Default enabled
preferred-lifetime
Syntax [no] preferred-lifetime {seconds | infinite}
Context config>router>router-advert>if
Description This command configures the remaining length of time in seconds that this prefix will continue to be
preferred, such as, time until deprecation. The address generated from a deprecated prefix should not
be used as a source address in new communications, but packets received on such an interface are
processed as expected.
Default 604800
Parameters seconds — Specifies the remaining length of time in seconds that this prefix will continue to be
7450 ESS Router Configuration Guide
Values
ipv4-prefix
ipv4-prefix-length
ipv6-prefix
ipv6-prefix-length
Values 1 — 128
preferred.
IP Router Configuration
a.b.c.d (host bits must be 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
0 — 128
Page 217