Alcatel-Lucent 7450 Configuration Manual page 168

Router Interface Commands
bfd
Syntax bfd transmit-interval [receive receive-interval] [multiplier multiplier] [echo-receive echo-
interval]
no bfd
Context config>router>interface
config>router>interface>ipv6
Description This command specifies the bi-directional forwarding detection (BFD) parameters for the associated
IP interface. If no parameters are defined the default values are used.
The multiplier specifies the number of consecutive BFD messages that must be missed from the peer
before the BFD session state is changed to down and the upper level protocols (OSPF, IS-IS, BGP or
PIM) is notified of the fault.
The no form of the command removes BFD from the router interface regardless of the IGP/RSVP.
Default no bfd
Parameters transmit-interval — Sets the transmit interval, in milliseconds, for the BFD session.
receive receive-interval — Sets the receive interval, in milliseconds, for the BFD session.
multiplier multiplier — Set the multiplier for the BFD session.
echo-receive echo-interval — Sets the minimum echo receive interval, in milliseconds, for the
cflowd-parameters
Syntax cflowd-parameters
no cflowd-parameters
Context config>router>interface
Description This command creates the configuration context to configure cflowd parameters for the associated IP
interfaces.
Page 168
Values 10 — 100000
Default
100
Values 10 — 100000
Default 100
Values 3— 20
Default 3
session.
Values
100 — 100000
Default 0
7450 ESS Router Configuration Guide