Alcatel-Lucent 7450 Configuration Manual page 205

The no form of the command disables the generation of ICMPv6 host and network unreachable
messages by this interface.
Default 100 10 (when IPv6 is enabled on the interface)
Parameters number — Determines the number destination unreachable ICMPv6 messages to issue in the time
seconds — Sets the time frame, in seconds, to limit the number of destination unreachable ICMPv6
link-local-address
Syntax link-local-address ipv6-address [preferred]
no link-local-address
Context config>router>if>ipv6
config>service>ies>if>ipv6
config>service>vprn>if>ipv6
Description This command configures the IPv6 link local address.
The no form of the command removes the configured link local address, and the router automatically
generates a default link local address.
Note that removing a manually configured link local address may impact routing protocols or static
routes that have a dependency on that address. It is not recommended to remove a link local address
when there are active IPv6 subscriber hosts on an IES or VPRN interface.
Parameters preferred — Disables duplicated address detection and sets the address to preferred, even if there is a
local-proxy-nd
Syntax [no] local-proxy-nd
Context config>router>if>ipv6
Description This command enables local proxy neighbor discovery on the interface.
The no form of the command disables local proxy neighbor discovery.
neighbor
Syntax neighbor [
no neighbor [
Context config>router>if>ipv6
7450 ESS Router Configuration Guide
frame specified in seconds parameter.
Values 10 — 1000
messages issued per time frame.
Values 1 — 60
duplicate address.
ipv6-address] [mac-address]
ipv6-address]
IP Router Configuration
Page 205