Alcatel-Lucent 7450 Configuration Manual page 506

Global Filter Commands
Description
This command configures redirect policies.
The no form of the command removes the redirect policy from the filter configuration only if the
policy is not referenced in a filter and the filter is not in use (applied to a service or network
interface).
Default none
Parameters redirect-policy-name — Specifies the redirect policy name. Allowed values are any string up to 32
log
Syntax log log-id [create]
no log
Context config>filter
Description
This command enables the context to create a filter log policy.
The no form of the command deletes the filter log ID. The log cannot be deleted if there are filter
entries configured to write to the log. All filter entry logging associations need to be removed before
the log can be deleted.
Special Cases Filter log 101 — Filter log 101 is the default log and is automatically created by the system. Filter
log 101 is always a memory filter log and cannot be changed to a Syslog filter log. The log size
defaults to 1000 entries. The number of entries and wrap-around behavior can be modified.
Default log 101
Parameters log-id — The filter log ID destination expressed as a decimal integer.
Page 506
characters long composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes. There is
no limit to the number of redirect policies that can be configured.
Values 101 — 199
7450 ESS Router Configuration Guide