Table of Contents
Advertisement
Alcatel-Lucent Enterprise
Chapter 2 Configuration
2.1 Dial Routing Interface Configuration Commands
This section describes all the commands to configure the Dial Routing interface. In order to access the configuration
environment for the said interface, you need to proceed as for the rest of the device interfaces, through the NET-
WORK command in the device configuration followed by the interface identifier:
*config
Config> network dialroute1
-- DR interface configuration --
dialroute1 config>
There are certain commands which are common for all the device's interfaces. These commands are described in
the manual on configuring common interfaces (ALU-Dm 772-I Common Configurations for Interfaces).
The following table shows the specific commands for this Dial Routing interface:
Command
? (HELP)
CONNECTION
LIST
NO
POOL-NAME
QUARANTINE-TIME
EXIT
2.1.1 Configuring connections
2.1.1.1 Adding a new connection
In order to add a new connection, use the CONNECTION command.
dialroute1 config>connection <id> default
This command creates a connection with the default values for the distinct parameters. The way to modify the para-
meter values will be explained further on in this manual.
The <id> parameter is a number that uniquely identifies the connection. This connection identifier must be distinct to
already existing connections. Contrariwise, the command will modify the previously configured connection paramet-
ers that have the said identifier.
Additionally, this identifier serves to link the connection with the IP destination accessed through the said connection.
For this, the ID static route identifier must coincide with the Dial Routing connection identifier that provides access to
the subnet specifying this route.
2.1.1.2 Modifying connection parameters
Once the connection has been created, in order to assign parameter values or change the previously assigned value
use the CONNECTION command with the different permitted options.
2.1.1.2.1 Modifying the destination telephone number
dialroute1 config>connection <id> destination-address <telephone number>
2.1.1.2.2 Modifying the user
dialroute1 config>connection <id> username <name>
2.1.1.2.3 Modifying the password
dialroute1 config>connection <id> password <password>
Dial Routing
Function
Lists the commands or their options.
Configures a connection.
Lists the current configuration.
Negates a command or establishes its default value.
Configures the pool name.
Configures the quarantine time.
Returns to the previous prompt.
2 Configuration
31
Advertisement
Table of Contents
