Alcatel-Lucent 7450 Configuration Manual page 153

no local-address
Context config>router>l2tp>group>tunnel
Description This command configures the local address.
Parameters ip-address — Specifies the IP address used during L2TP authentication.
local-name
Syntax local-name host-name
no local-name
Context config>router>l2tp>group
config>router>l2tp>group>tunnel
Description This command creates the local host name used by this system for the tunnels in this L2TP group
during the authentication phase of tunnel establishment. It can be used to distinguish tunnels.
The no form of the command removes thename from the configuration.
Default local-name
Parameters host-name — Specifies the host name, up to 64 characters in length, that the router will use to identify
max-retries-estab
Syntax max-retries-estab max-retries
no max-retries-estab
Context config>router>l2tp>group
config>router>l2tp>group>tunnel
Description This command configures the number of retries allowed for this L2TP tunnel while it is established,
before its control connection goes down.
The no form of the command removes the value from the configuration.
Default no max-retries-estab
Parameters
max-retries — Specifies the maximum number of retries for an established tunnel.
max-retries-not-estab
Syntax max-retries-not-estab max-retries
7450 ESS Router Configuration Guide
itself during L2TP authentication.
Default no local-name
Default no max-retries-estab
Values 2 — 7
IP Router Configuration
Page 153