Alcatel-Lucent 7450 Configuration Manual page 135

-------------------------------------------------------------------------------
No. of Static Routes: 1
===============================================================================
*B:Dut-C>config>router#
*B:Dut-C>config>router# show router "management" static-route ipv6
===============================================================================
Static Route Table (Router: management)
===============================================================================
Prefix
Next Hop
-------------------------------------------------------------------------------
1::/96
-------------------------------------------------------------------------------
No. of Static Routes: 1
===============================================================================
*B:Dut-C>config>router#
static-route-entry
Syntax static-route-entry {ip-prefix/prefix-length} [mcast] indirect {ip-address}
Context config>router
Description This command enables the resolution of a static route prefix to an indirect tunnel next-hop.
Default No static routes are defined.
Parameters ip-prefix/prefix-length — The destination address of the static route.
indirect ip-address — Specifies that the route is indirect and specifies the next hop IP address used to
ip-address — The IP address of the IP interface. The ip-addr portion of the address command
7450 ESS Router Configuration Guide
3000::AC1F:7567
Values
ipv4-prefix
ipv4-prefix-length
reach the destination.
The configured ip-addr is not directly connected to a network configured on this node. The
destination can be reachable via multiple paths. The indirect address can only resolved from
dynamic routing protocol. Another static route cannot be used to resolve the indirect address.
The ip-addr configured can be either on the network or the access side and is normally at least
one hop away from this node.
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation.
Values
ipv4-address
Family: IPv6
Tag
Interface
0
management
a.b.c.d (host bits must be 0)
0 — 32
a.b.c.d (host bits must be 0)
IP Router Configuration
Met Pref Type Act
1 5 NH Y
Page 135