Alcatel-Lucent 7450 Configuration Manual page 509

summary
Syntax summary
Context config>filter>log
Description This command enables the context to configure log summarization. These settings will only be taken
into account when syslog is the log destination. Note that summary settings will only be taken into
account in case the log destination is syslog.
Parameters none
summary-crit
Syntax summary-crit dst-addr
summary-crit src-addr
no summary-crit
Context config>filter>log>summary
Description This command defines the the key of the index of the minitable. If key information is changed while
summary is in no shutdown, the filter summary minitable is flushed and recreated with different key
information. Log packets received during the reconfiguration time will be handled as if summary was
not active.
The no form of the command reverts to the default parameter.
Default
dst-addr
Parameters dst-addr — Specifies that received log packets are summarized based on the destination IP, IPv6, or
src-addr — Specifies that received log packets are summarized based on the source IP, IPv6 or MAC
wrap-around
Syntax [no] wrap-around
Context config>filter>log
Description This command configures a memory filter log to log until full or to store the most recent log entries
(circular buffer).
Specifying wrap-around configures the memory filter log to store the most recent filter log entries
(circular buffer). When the log is full, the oldest filter log entries are overwritten with new entries.
The no form of the command configures the memory filter log to accept filter log entries until full.
When the memory filter log is full, filter logging for the log filter ID ceases.
Default wrap-around
7450 ESS Router Configuration Guide
MAC address.
address.
Filter Policies
Page 509