Configuring A Confederation - Alcatel-Lucent 7450 Configuration Manual

Configuring a Confederation

Configuring a confederation is optional. The AS and confederation topology design should be
carefully planned. Autonomous system (AS), confederation, and BGP connection and peering
parameters must be explicitly created on each participating router. Identify AS numbers,
confederation numbers, and members participating in the confederation.
Refer to the BGP section for CLI syntax and command descriptions.
Use the following CLI syntax to configure a confederation:
CLI Syntax: config>router
The following example displays the commands to configure the confederation topology diagram
displayed in
NOTES:
•
•
The following displays a confederation example.
A:ALA-B>config>router# info
#------------------------------------------
# IP Configuration
#------------------------------------------
#------------------------------------------
A:ALA-B>config>router#
7450 ESS Router Configuration Guide
confederation confed-as-num members member-as-num
Figure 2 on page 39.
Confederations can be preconfigured prior to configuring BGP connections and peering.
Each confederation can have up to 15 members.
interface "system"
address 10.10.10.103/32
exit
interface "to-104"
shutdown
address 10.0.0.103/24
port 1/1/1
exit
autonomous-system 100
confederation 2002 members 200 300 400
router-id 10.10.10.103
IP Router Configuration
Page 89