Alcatel-Lucent 7450 Configuration Manual page 334

Debug Commands
Parameters
ip-address — Only displays the interface information associated with the specified IP address.
ip-int-name — Only displays the interface information associated with the specified IP interface name.
packet
Syntax packet [ip-int-name | ip-address] [headers] [protocol-id]
no packet [ip-int-name | ip-address]
Context debug>router>ip
Description This command enables debugging for IP packets.
Parameters ip-int-name — Only displays the interface information associated with the specified IP interface name.
ip-address — Only displays the interface information associated with the specified IP address.
headers — Only displays information associated with the packet header.
protocol-id — Specifies the decimal value representing the IP protocol to debug. Well known protocol
route-table
Syntax route-table [ip-prefix/prefix-length]
route-table ip-prefix/prefix-length longer
no route-table
Context debug>router>ip
Description This command configures route table debugging.
Parameters ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
longer — Specifies the prefix list entry matches any route that matches the specified ip-prefix and pre-
Page 334
Values ipv4-address
Values 32 characters maximum
Values
32 characters maximum
numbers include ICMP(1), TCP(6), UDP(17). The no form the command removes the protocol
from the criteria.
Values 0 — 255 (values can be expressed in decimal, hexidecimal, or binary)
Values ipv4-prefix
ipv4-prefix-length
fix mask length values greater than the specified mask.
a.b.c.d (host bits must be 0)
a.b.c.d (host bits must be 0)
0 — 32
7450 ESS Router Configuration Guide