Alcatel-Lucent 7450 Configuration Manual page 170

Router Interface Commands
Context config>router>interface
Description This command assigns an existing CPU protection policy for the interface. The CPU protection
policies are configured in the config>sys>security>cpu-protection>policy cpu-protection-policy-id
context.
Parameters policy-id — Specifies an existing CPU protection policy.
delayed-enable
Syntax delayed-enable seconds
no delayed-enable
Context config>router>if
Description This command creates a delay to make the interface operational by the specified number of seconds
The value is used whenever the system attempts to bring the interface operationally up.
Parameters seconds — Specifies a delay, in seconds, to make the interface operational.
dist-cpu-protection
Syntax dist-cpu-protection policy-name
no dist-cpu-protection
Context config>router>if
Description
This command assigns a Distributed CPU protection policy for the interface.
enable-ingress-stats
Syntax [no] enable-ingress-stats
Context config>router>interface
config>service>ies >interface
config>service>vprn>interface
config>service>ies>sub-if>grp-if
config>service>vprn>sub-if>grp-if
Description This command enables the collection of ingress interface IP stats. This command is only appliable to
IP statistics, and not to uRPF statistics.
If enabled, then the following statistics are collected:
Page 170
Values 1 — 255
Values 1 — 1200
• IPv4 offered packets
7450 ESS Router Configuration Guide