Alcatel-Lucent 7450 Configuration Manual page 640

Global Commands
Unlike other commands and parameters where the default state is not indicated in the configuration
file. The shutdown and no shutdown states are always indicated in system generated configuration
files.
template-set
Syntax template-set {basic | mpls-ip | l2-ip}
Context config>cflowd>collector
Description This command specifies the set of templates sent to the collector when using cflowd Version 9 or
Version 10.
Default basic
Parameters basic — Basic flow data is sent.
mpls-ip — Extended flow data is sent that includes IP and MPLS flow information.
l2-ip — Extended flow data is sent that includes Layer 2 (ethernet) and IP flow information.This
export-mode
Syntax export-type [automatic | manual]
Context config>cflowd
Description This command can be used to control how exports are generated by the cflowd process. The default
behavior is for flow data to be exported automatically based on the active and inactive time-out
values. The alternative mode is manual in which case flow data is only exported when the command
"tools perform cflowd manual-export" is issued. The only exception is if the cflowd cache
overflows, in which case the normal automatic export process is used.
Default export-mode automatic
Parameters
automatic — Cflowd flow data is automatically generated.
manual — Cflowd flow data is exported only when manual triggered.
inactive-timeout
Syntax inactive-timeout seconds
no inactive-timeout
Context config>cflowd
Description This command specifies the amount of time, in seconds, that must elapse without a packet matching a
flow in order for the flow to be considered inactive.
Page 640
template is only applicable for v10(IPFIX) collectors.
7450 ESS Router Configuration Guide