Alcatel-Lucent 7450 Configuration Manual page 172

Router Interface Commands
Description
This command enables local proxy ARP on the interface.
Default no local-proxy-arp
ip-load-balancing
Syntax ip-load-balancing {source|destination}
no ip-load-balancing
Context config>router>if
Description
This command specifies whether to include source address or destination address or both in LAG/
ECMP hash on IP interfaces. Additionally, when l4-load-balancing is enabled the command applies
also to inclusion of source/destination port in the hash inputs.
The no form of this command includes both source and destination parameters.
Default no ip-load-balancing
Parameters source — Specifies to use source address and (if l4-load balancing is enabled) source port in the
destination — Specifies to use destination address and (if l4-load balancing is enabled) destination
lag-link-map-profile
Syntax lag-link-map-profile link-map-profile-id
no lag-link-map-profile
Context config>router>if
Description This command assigns a pre-configured lag link map profile to a SAP/network interface configured
on a LAG or a PW port that exists on a LAG. Once assigned/de-assigned, the SAP/network interface
egress traffic will be re-hashed over LAG as required by the new configuration.
The no form of this command reverts the SAP/network interface to use per-flow, service or link hash
as configured for the service/LAG.
Default no lag-link-map-profile
Parameters link-map-profile-id — An integer from 1 to 32 that defines a unique lag link map profile on which the
ldp-shortcut
Syntax [no] ldp-shortcut
Context config>router
Page 172
hash, ignore destination address/port.
port in the hash, ignore source address/port.
LAG the SAP/network interface exist.
7450 ESS Router Configuration Guide