Alcatel-Lucent 7450 Configuration Manual page 160

Router L2TP Commands
Description
This command configures the idle timeout to wait before being disconnect. The no form indicates
that the parameter will be removed from the configuration and that the value specified on group level
will be taken.
Parameters idle-timeout — Specifies the idle timeout, in seconds.
infinite — Specifies that the tunnel will not be closed when idle.
peer
Syntax peer ip-address
no peer
Context config>router>l2tp>group>tunnel
Description This command configures the peer address.
The no form of the command removes the IP address from the tunnel configuration.
Default
no peer
Parameters ip-address — Sets the LNS IP address for the tunnel.
preference
Syntax preference preference
no preference
Context config>router>l2tp>group>tunnel
Description
This command configures a preference number that indicates the relative preference assigned to a
tunnel when using a weighted session assignment.
The no form of the command removes the preference value from the tunnel configuration.
Default no preference
Parameters preference — Specifies the tunnel preference number with its group. The value 0 corresponds to the
remote-name
Syntax remote-name host-name
no remote-name
Context config>router>l2tp>group>tunnel
Page 160
Values 0 — 3600
highest preference.
Values 0 — 16777215
7450 ESS Router Configuration Guide