Alcatel-Lucent 7450 Configuration Manual page 206

Hide thumbs Also See for 7450:

Table of Contents

Router Interface Commands

This command configures an IPv6-to-MAC address mapping on the interface. Use this command if a

directly attached IPv6 node does not support ICMPv6 neighbor discovery, or for some reason, a static

address must be used. This command can only be used on Ethernet media.

The ipv6-address must be on the subnet that was configured from the IPv6 address command or a

link-local address.

ipv6-address — The IPv6 address assigned to a router interface.

mac-address — Specifies the MAC address for the neighbor in the form of xx:xx:xx:xx:xx:xx or xx-

xx-xx-xx-xx-xx.

proxy-nd-policy

proxy-nd-policy policy-name [policy-name...(up to 5 max)]

no proxy-nd-policy

config>router>if>ipv6

This command configure a proxy neighbor discovery policy for the interface.

policy-name — The neighbor discovery policy name. Allowed values are any string up to 32

ipv6-address:

characters long composed of printable, 7-bit ASCII characters. If the string contains special

characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes. The

specified policy name(s) must already be defined.

x:x:x:x:x:x:x:x (eight 16-bit pieces)

x:x:x:x:x:x:d.d.d.d

7450 ESS Router Configuration Guide